As an Amazon Associate I earn from qualifying purchases.
Porcelain is dense and absorbs very little water; ceramic is softer and easier to cut. Both are fixed with cement-based tile adhesive and the joints are filled with grout. A tiled floor is rigid, so movement has to be taken up by joints at the walls and in large areas.
Layout comes first
Do not start against a wall. Snap reference lines so that cut tiles at opposite walls are about the same size and none is a thin sliver. The planner shows exactly which tiles are cut and to what size, so you can shift the start point before buying adhesive.
Key numbers
| Rule | Typical value |
|---|---|
| Grout joint | 2–3 mm for rectified tiles, 3–5 mm for others |
| Movement joint at walls | 5–6 mm, filled with silicone |
| Adhesive coverage | At least 80% in dry rooms, 95% in wet areas |
| Offset for long tiles | Max 33% when any side is longer than about 45 cm |
| Smallest cut | Avoid pieces narrower than a third to half a tile |
| Spare | 10%, 15% for diagonal or herringbone |
Installation in short
- Make the floor flat and prime it. Large tiles need a flatter floor than small ones.
- Snap layout lines from the planner's start point.
- Mix flexible C2 adhesive and comb it in one direction with a notched trowel sized for the tile.
- Back-butter large tiles with a thin layer, then press and slide them into place across the comb lines.
- Use spacers, and levelling clips for tiles 45 cm and longer.
- Lift a tile now and then to check coverage.
- After 24 hours, grout diagonally across the joints and sponge clean.
- Seal the wall joints with silicone, not grout.
Why the 33% rule? Long tiles have a slight bow from the kiln. With a half offset the high middle of one tile meets the low ends of the next, which shows as lippage. A third offset or less hides it.
Browse porcelain floor tile on Amazon
Spot an error or something out of date? Tell us and we will fix it. How we check our information